Stove Assembly Prior To Installation; Airmate Assembly; Rear Heat Defl Ector Assembly; Pedestal Assembly - Regency Vancouver F2402M Owners & Installation Manual

Minimum Overall Depth (Y) of Floor Protector
Residential
Alcove
Unit
Close Clearance Close Clearance
Z
Z
Z Y
Z
Medium F2402M
46" (1168 mm)
with Airmate
6" (152 mm) 45"* (1143 mm) 5" (127 mm)
45" (1143 mm) 5" (127 mm)
45"* (1143) 5" (127 mm)
with Rear Defl ector
mm) 6" (152 mm) 45" (1143
mm) 5" (127 mm) 45" (1143 mm) 5"
(127 mm) 45" (1143) 5" (127
mm)
Diagram 1
Diagram 2
Diagram 3
Regency Freestanding Woodstove
*The rear clearance to combustibles is less
than 6", for corner installations the rear corners
may be angled to take advantage of the closer
clearances.
Residential
STOVE ASSEMBLY
Mobile Home
"C" Vent
INSTALLATION
All units require either the pedestal or 4 legs at-
Y
tached to the base. The F2402M stove requires
Y
Y
46" (1168
either the Airmate or Rear Heat Defl ector on top
of the stove. Clearances to combustible materials
vary depending on whether the airmate or rear
heat defl ector is installed, so be sure to check
the clearance information on pages 7 and 8.

Airmate Assembly

Side Shield
1) The airmate sits on top of the stove with
the slots in the sides fi tting over the curved
defl ector on the rear stove top. See diagram
1. Discard the Rear Heat Defl ector that is
supplied with the unit, it is not required if the
airmate is installed.
2) Center the airmate and push it forward to the
front of the stove. The back of the airmate
should be level with the back and sides of
the rear heat shield. See diagrams 2 & 3.
Rear Heat Defl ector
The rear heat defl ector is supplied with the stove
PRIOR TO
Diagram 4
Assembly
INSTALLATION
and must be installed unless
the optional airmate has
been selected. It
stops the heat radi-
ated from the fl ue
collar from over-
heating the rear
wall. The rear heat defl ector is installed on top
of the rear heat shield, as shown in diagram 4.

Pedestal Assembly

9