Configuring The Network Interface - Epson EMP 7900 Network Manual

Configuring the Network Interface

Configure the network interface for use on a TCP/IP network.
1. Make sure that the printer is turned on, and the LCD displays READY.
2. Press the Menu r button on the printer to enter the printer's menu system.
3. Press d to highlight NETWORK SETUP, then press r.
4. Press r, then d to highlight ENABLE.
5. Press OK. A checkmark appears next to ENABLE to show that it's selected.
6. Press r, then d to highlight IP ADDRESS SETTING.
7. Press r, then press u or d to choose one of the following IP configuration
settings:
❏ Choose AUTO if your network uses a DHCP server to configure your
network devices' IP settings automatically.
❏ Choose PANEL if you would like to configure the printer's IP settings
manually.
8. Press OK. A checkbox appears next to the setting you selected.
9. Press l, to go back, then do one of the following:
❏ If you selected AUTO as the IP address setting, press the
button to exit the printer menu. Then continue with step 14.
❏ If you selected PANEL as the IP address setting, continue with step 10.
10. Press d to highlight IP, SM, DG SETTING, then press r. The LCD displays
the IP address.
11. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r. The
LCD displays the subnet mask.
12. Press u or d to change each octet value, then press r to select the next
octet. When you have changed the value of the last octet, press r. The
LCD displays the default gateway.
Setting Up Your System for Network Printing
Pause
17