Epson EMP 71 Instruction Manual page 57

Problem and Alarm Display Indicator
Indicator
Cause
Status
Steady red High
internal
temperature
Flashing Problem
red with lamp
(1-second
intervals)
Flashing Internal
red problem
(2-second
intervals)
Remedy or Status
The lamp will turn off automatically and projection
will stop. Wait for about 5 minutes without operating
the projector. After 5 minutes, disconnect the power
plug and connect it again.
If the projector overheats, check the following two
points.
• Is the setting-up location well ventilated?
Check that the air inlet and air outlet are clear, and
that the projector is not positioned against a wall.
• Is the air filter blocked with dust?
If the air filter is dirty, it should be cleaned.
After reconnecting the power plug the operating
condition is restored. Press the power button to
switch on the power supply. If the projector
continues to overheat even after the above points
have been checked, or if the indicators show a
problem when the power is turned back on, stop
using the projector, disconnect the power cord from
the electrical outlet, and contact your dealer or the
nearest address provided at "International Warranty
Conditions" in "Safety Instructions/World-Wide
Warranty Terms" included in the package.
Replace with new lamp.
Model No: ELPLP16
If the lamp is broken, handle pieces carefully to
avoid injury, and contact your dealer or the nearest
address provided at "International Warranty
Conditions" in "Safety Instructions/World-Wide
Warranty Terms" included in the package for repair
(video projection is not possible unless the lamp is
replaced).
If the lamp or lamp cover is not attached securely,
follow the replacement instructions to attach it
securely.
Stop using the projector, disconnect the power cord
from the electrical outlet, and contact your dealer or
the nearest address provided at "International
Warranty Conditions" in "Safety Instructions/World-
Wide Warranty Terms" included in the package.
See
Page
14
65
66
-
66
-
55