Epson EMP 71 Instruction Manual page 28

Projector
Computer
When no S-Video
input
26
3.
Remote control
S-Video
Video
4.
Press the Source button on the projector or
the Computer, S-Video or Video button on
the remote control to select the video source
you wish to project.
Each time the Source button on the projector
is pressed, the video source cycles between
Computer, S-Video and Video.
If there is no input at the S-Video port, the
Source button switches the video source
from Computer to Video.
Tip:
If projecting a component video picture, change
the setting to Computer.
Switch on power to the computer or A/V
device to begin projection.
The "No-Signal" display disappears, and a
video signal from the computer or A/V
device is projected.
Tip:
• If the "No-Signal" display remains, check the
connections again.
• If the same static image is projected for some
time, the video projection may contain an
afterimage.