Epson EB-G5200W User Manual page 74

Problem Solving
Check
Is the computer set for dual display?
Only when projecting computer images
Is the correct resolution selected?
Only when projecting computer images
f Image colors are not right
Check
Do the input signal settings match the signals from the
connected device?
Is the image brightness adjusted correctly?
Are the cables connected correctly?
Is the "Contrast g " setting adjusted correctly?
Is the color adjusted correctly?
Are the color saturation and tint adjusted correctly?
Only when projecting images from a video source
Images appear dark
f
Check
Are the image brightness and luminance adjusted correctly?
Is the "Contrast g " setting adjusted correctly?
Is the lamp due for replacement?
If dual display is activated in the "Display Properties" of the computer's control panel, only about half of the
image on the computer screen is projected. To display the entire image on the computer screen, turn off the
dual display setting. s Computer video driver documentation
Set the computer so that the signals being output are compatible with the projector.
s "List of Supported Monitor Displays"
Change the following settings according to the signal for the connected equipment.
When projecting images from equipment connected to Computer1/2 input port or BNC input port
s "Signal" - "Input Signal" p.43
When projecting images from equipment connected to Video1/2 or S-Video s "Signal" - "Video Signal"
p.43
Adjust the "Brightness" setting from the configuration menu. s "Image" - "Brightness"
Check that all the cables required for projection are securely connected. s Quick Start Guide
Adjust the "Contrast" setting from the configuration menu. s "Image" - "Contrast"
Adjust the "Color Adjustment" setting from the configuration menu. s "Image" - "Color Adjustment"
Adjust the "Color Saturation" and "Tint" settings from the configuration menu. s "Image" - "Color
Saturation", "Tint" p.41
Adjust the "Brightness" and "Brightness Control" settings from the configuration menu.
s "Image" - "Brightness" p.41 s "Settings" - "Brightness Control"
Adjust the "Contrast" setting from the configuration menu.
s "Image" - "Contrast" p.41
When the lamp is nearly ready for replacement, the images become darker and the color quality becomes
poorer. When this happens, replace the lamp with a new lamp. s
Remedy
p.116 s Computer documentation
Remedy
Remedy
p.44
p.85
74
p.41
p.41
p.41