Epson EB-G5200W User Manual page 72

Problem Solving
f The message "Not Supported" is displayed.
Check
Is the image signal format setting correct?
Only when projecting images from a video source
Do the image signal resolution and the refresh rate
correspond to the mode?
Only when projecting computer images
f The message "No Signal."is displayed.
Check
Are the cables connected correctly?
Is the correct input port selected?
Is the power for the computer or video source turned on?
Are the image signals being output to the projector?
Only when projecting images from a laptop
computer or a computer with a built-in LCD screen
f Images are fuzzy or out of focus
Check
Is the focus adjusted correctly?
Is the projector at the correct distance?
Is the Keystone adjustment value too large?
Change the setting according to the signal for the connected equipment. s "Signal" - "Video Signal"
Refer to the computer's documentation for how to change the image signal resolution and the refresh rate
output from the computer. s "List of Supported Monitor Displays"
Check that all the cables required for projection are securely connected. s Quick Start Guide
Change the image by pressing the [Source Search] button on the remote control or the control panel.
p.19
s
Turn the power on for the equipment.
If the image signals are only being output to the computer's LCD monitor or to the accessory monitor, you
need to change the output to an external destination as well as the computer's own monitor. For some
computer models, when the image signals are output externally, they no longer appear on the LCD monitor
or accessory monitor. s Computer's documentation, under a title such as "External output" or "Connecting
an external monitor".
If the connection is made while the power of the projector or computer is already turned on, the function
[Fn] key that changes the computer's image signal to external output may not work. Turn the power for the
computer and the projector off and then back on again.
Turn the focus ring to adjust the focus. s Quick Start Guide
Is it projecting outside of the recommended projection distance range?
Setup within the recommended range. s
Lower the projection angle to reduce the amount of keystone correction. s Quick Start Guide
Remedy
p.116
Remedy
Remedy
p.99
72
p.43