When using the edge guide, position
the face of the edge guide firmly against
the edge of the workpiece.
This will help to make a true cut without
binding the
blade. The edge of the workpiece
must be straight for the cut to be straight.
Use
caution to prevent the blade from binding in the cut.
SETTING
THE BEVEL ANGLE
,_
WARNING:
Always unplug the saw before making any adjustments.
Failure
to unplug the saw could result in accidental
starting,
which can cause serious
personal injury.
1.
Fig. 14
/
2.
Bevel Pointer
3.
4.
Unplug the saw.
Loosen bevel adjustment
lever (Fig. 14).
Raise the motor-housing
end of the saw until the
desired angle setting is
indicated on the bevel scale.
Tighten the bevel
adjustment
lever securely.
Bevel Adjustment
Lever
28195 Manual_Revised_07-0623
Page 24