Bevel Setting - Craftsman 320.28060 Owner's Manual

TO ADJUSTTHE BEVEL SETTING
1. Unplug the saw,
WARNING:
Failure to unplug the saw could result in accidental starting causing i
possible serious personal injury
I
2, Loosen bevel adjustment knob (See Fig, 17)
3. Raise the motor housing end of the saw until you reach the desired angle setting on the bevel
scale (See Fig, 17),
4. Tighten Knob securely:
Z'_ WARNING: Attempting a bevel cut with°ut the kn°b being securely t'ghten d ::: 1 injury e. result in serious
:::: : ,,,,,,,,,,,,,,,,I,,,H,,,, i, i1, ,i , ,u L J •
POSITIVE 0° BEVEL STOP (See Fig. 17)
Your saw has a positive 0 ° bevel stop, it was adjusted at the factory to assure 0 ° angle of the saw
blade for 90 ° cuts However shipping can cause misalignment,
To Check
1. Unplug the saw,
!_ WARNING:
Failure to unplug the saw could result in accidental starting causing
possible serious personal injury
2. Place saw in an upside down position on workbench (See Fig t7)
3, Use a carpenter's square to check the squareness of the saw blade to the base on your saw
Fig. 17
Bevel
3arpenter's Edge Guide
Square Retaining Screw
,,,,,,, ,,,,
To Adjust
1. Unplug the saw
WARNING:
Failure to unplug the saw could result in accidental starting causing
_ossible serious personal iniury. .......................
2, Loosen bevel adjustment knob_
3. Loosen screw and adjust base until square with saw blade,
4o Tighten screw and knob securely._
I,,,,,,,N,,H,,,, ,,I I ...........................................
Z_ WARNING:
Attempting to make cuts without knob securely tightened can result in !
serious injury.
I
,,,1,,,,,,, ,,1,,1111 ii ,,I,,,,I,,,,H,HI I
22