Craftsman 320.28195 Product Manual page 29

3. Using a slotted screwdriver,
remove the black, plastic
cap on each side of
the motor (Fig. 20), and
carefully withdraw the
spring-loaded brush
assemblies. Keep brushes
clean and sliding freely in
their guide channels.
NOTE: To reinstall the same
brushes, make sure that
the brushes go back in the
same way they came out.
This will avoid the need for a
"run-in" period.
4.
5.
Fig. 20
Plastic Cap
Insert new brush assemblies into the guide channels with the carbon part
going in first, being certain to fit the two metal "ears" into their slots in the
channel (Fig. 20).
Remember to replace both end caps after inspecting or servicing brushes.
Tighten the caps snugly, but do not over-tighten. Before use, the saw should be
allowed to "RUN IN" (run at no load without a blade) for 5 minutes to seat the
new brushes properly.
28195 Manual_Revised_07-0623 Page 29