Edge Guide - Craftsman 320.28195 Product Manual

USING A STRAIGHT EDGE
,_ WARNING: Always securely clamp and support the workpiece. Always
maintain proper control of the saw. Failure to clamp and support the workpiece,
combined with loss of control of the saw, could result in serious injury.
You can make an efficient rip guide by clamping a straight edge to your
workpiece. Fig. 12
1. Always allow the blade to
reach full speed, and then
carefully guide the saw
into the workpiece. Do not
bind the blade in the cut.
2. Carefully guide the saw
along the straight edge for
a straight rip cut (Fig. 12).
3. Push the saw forward
slowly enough that the
blade is not laboring.
EDGE GUIDE
The saw comes with an edge guide, it allows you to make accurate parallel cuts.
The edge guide attaches to the saw base and is secured in place with a turn
SCrew.
USING THE EDGE GUIDE
Always use a guide when making long or wide rip cuts with your saw. You can
use either a straight edge or use the edge guide that was included with the saw.
,_ WARNING: Always unplug the saw before making any adjustments. Failure
to unplug the saw could result in accidental starting, which can cause serious
personal injury.
1. Unplug the saw from the power source.
2,
3,
4.
Position the edge guide
so that the ruler side of
the arm is facing up. Slide
the arm of the edge guide
through the mounting
slots at the front of the
saw base (Fig 13).
Adjust the edge guide to
the desired width of cut.
Tighten the edge-guide
lock knob.
Fig. 13
28195 Manual_Revised_07-0623 Page 23