Table of Contents
Advertisement
•
If the blade was too close to the miter gage
groove, back the bracket away with the blockof
wood and hammer.
•
Tightenthe screws, raise the blade and recheck.
•
Repeat untilblade is parallelto miter gage groove,
•
If the blade is not parallel, adjustthe front table
bracket. Tilt the blade to 45 ° with the blade lock
handle and bevel handwheal.
•
Fmm the beck of the saw, loosen the boltsholding
the front table bracket,as well as the rear table
bracket.
•
Repositionthe blade to 90 ° with the bevel hand-
wheel end blade lock handle.
•
Lowerthe blade and movethe bracketsas needed,
Retiglten all bracket screws.
•
Raise the blade and recheck. Repeat untilthe
blade is parallelto the miter gage groove.
•
Place the throat plate in the opening and push it
toward the rear of sew base to engage the spring
clip.
Note; The keyslot in the throat plate willdrop over the
front screw,
•
Tightenthe screw, Do not allowthe throat plata to
bow up above the table surface.
SAW TABLE VIEW FROM BELOW
REAR
SAWTABLE
TABLEBRACKET
/
BRACKET/
r'"l
I
SCREW(sl
/
l
I 7--7
L \
I
FRONT /
FRONT
BRACKET
TABLEBRACKET
SCREW(S)
Fig. 40
SETTING THE BEVEL STOPS AND INDICATOR
See Figures 41 and 42.
A
WARNING:
Make sure the switch is off, the
switchkey is removed, and your sew is
unplugged.Failure to do so could resultin
accidental starting, rasuitingin sedous personal
ir_u_.
The bevel scale should show 0 ° when the blade is set
verticalat 90° to table, and 45 ° when blade is at 45 °
tilt,
•
Raise the blade all the way up by turningthe height
handwhsel. Lift the blade guard.
•
Loosen bevel lock handle and tam the bevel
handwhselclockwiseto tiltthe blade, Raveme it
and turn the handwheel counterclockwise until it
stops,
•
Check the bladeangle with a combinationsquare.
Don't letthe square touch a blade tooth, The blade
shouldbe at 90° and the scala indicatorat 0 °.
Note: The scale indicatoris the plastic plate on the
scale at the front of the cabinet.
•
Ifthe scale indicatordoes not point to 0 °, loosen
the scale indicatorwith a screwdriver,adjust it
within the slot, and retightenthe screw.
•
If the blade angle Is wrong, adjustthe 90 ° stop
screw (leftof the blade, lookingfrcm the front), Start
by turning the 90 ° stop screw three or four rums
with a 4 mm hex key.
4mm
HEXKEY
90°STOPSCREW
45' STOP SCREW
Fig. 41
•
Turn the bevel handwheel clockwiseonce, then
beck counterclockwise to square blade with table.
•
Tightenthe 90 ° stop screw and recheck that the
blade is square in a 90" position.If not, repeat,
When the blade is square, checkthe scala indica-
tor. If it is not at zero, reset the scale indicatoras
before.
CRRFrSNRN" TABLESAW316._83g0
32
Advertisement
Table of Contents
