Control Panel - Jenn-Air JES8750BAB Use & Care Manual

O C
VEN OOKING

Control Panel

A B C D
The control panel is designed for ease in programming. The display window shows options for each function and moves from step
to step through the programming process. Control panel features vary by model. Oven display above is programmed for a bake
operation.
A Rapid Preheat Use to decrease preheating time.
(select models)
B Convect Use for convection baking and roasting.
(select models)
C Bake Use for baking and roasting.
D Broil Use for broiling and top browning.
E TIMER 1 Sets timer.
F Display Displays oven functions, options and
window time of day.
G TIMER 2 Sets timer.
H Number Pads Use to enter time and temperature,
or to enter Favorites names.
I Favorites Use to access, program or save
baking cycles.
J More Options Use to access additional features.
K Clean Use to set self-clean cycle.
L Setup Use to view or change factory
default settings.
M Warm Zone Use to turn Warming Zone on and off.
N Warm Drawer Use to operate the Warming Drawer.
(select models)
O Oven Light Use to turn the oven light on or off.
P CANCEL Cancels all operations except Timer,
Clock, Favorites, Setup and Warm
Drawer.
Q Quickset pads Use to select options in display
window (next to display window
on both sides).
E
I J K L M
F
N O P
Quickset Pads
Quickset pads are located on each side of the display window
and are used to select the desired function or option in the
display window. To select the option or function, press the
Quickset pad next to the word.
If you need to back out of a function or option in the display,
press the Back pad. When your programming is complete,
press the Enter pad or wait four seconds and the function will
start automatically.
Up arrows indicate additional screens with additional options.
Press the Quickset pads next to the arrows to scroll through
the display.
Important: Four seconds after entering the function,
option, number or letter, the function will automatically be
entered. If more than 30 seconds elapse between steps in
programming, the function will be canceled and the
display will return to the previous display.
Clock
Setting the Clock:
1. Press the Setup pad.
2. Select CLOCK using the Quickset pads.
3. Select TIME.
4. Enter the time using the number pads.
5. Press Enter pad.
6. Select AM or PM in 12 hour mode. (For 24 hour clock, see
page 14.)
7. To exit the Setup mode, press Setup pad.
13
G H
Q
Cont.