Control Panel - Jenn-Air Use And Care Manual

O C
VEN OOKING

Control Panel

A B C
I J
The control panel is designed for ease in programming. The display window on the control shows time of day, timer and oven functions.
Control panel shown includes Convect and other model specific features. (Styling may vary depending on model.)
A Clean Use to set self-clean cycle.
B Keep Warm Use to keep cooked food warm in oven.
C Toast Use for toasting bread and products
toasted in toaster or toaster oven.
D Broil Use for broiling and top browning.
E Bake Use for baking and roasting.
F Cancel Cancels all operations except Timer and
Clock.
G Oven Light Use to turn the upper or lower oven light
on or off.
H Number Pads Use to set time and temperature.
I Drying For drying fruits, vegetables and herbs.
J Proofing For proofing or allowing yeast bread
products to rise prior to baking.
K Convect Roast Use for convection roasting.
L Convect Bake Use for convection baking.
M Timer 1 or 2 Sets the timer.
N Clock Sets the clock.
O Cook & Hold Bakes for a preset time, then keeps food
warm for 1 hour.
P Delay Programs the oven to start baking or
cleaning at a later time.
Q Favorite Use to set and save a specific Cook
& Hold procedure.
R Autoset Use to quickly set temperatures.
Using the Touchpads
•
Press the desired pad.
•
Press the number pads to enter time or temperature.
•
Or, press the Autoset pad to enter temperature.
•
A beep will sound when any pad is touched.
•
A double beep will sound if a programming error occurs.
D E
K L M
F G
N O P
Note: Four seconds after entering the time or tempera-
ture it will automatically be entered. If more than 30
seconds elapse between touching a function pad and the
number pads, the function will be canceled and the display
will return to the previous display.
Clock
The clock can be set to display time in a 12-hour or 24-hour
format. The clock is set at the factory for the 12-hour format.
To change the clock to 24-hour format:
1. Press and hold the Upper Cancel pad and
Favorite pad for three seconds.
• 12 Hr flashes in the display.
2. Press the Autoset pad to select 24 Hr;
press again to select 12 Hr.
3. Set the time of day following the directions in
the To Set the Clock section.
To set the Clock:
1. Press the Clock pad.
• The time of day flashes in the display.
• Colon flashes in the display.
2. Press the appropriate number pads to set the time of day.
3. Press the Clock pad again or wait four seconds.
• The colon will remain on.
When electrical power is supplied or after a power interrup-
tion, the last clock time before power was interrupted will
flash.
To recall the time of day when another time function is
showing, press the Clock pad.
7
H
Q R
Upper
Cancel
Favorite
Autoset
Clock