Configuring The Destination For Appletalk Networks - Canon imagePROGRAF iPF750 MFP M40 User Manual

Configuring the Destination for AppleTalk Networks

To print over an AppleTalk network, activate the AppleTalk protocol and configure the destination as follows.
Activating AppleTalk on the printer
Important
• By factory default, the AppleTalk protocol is disabled on the printer.
1.
On the Tab Selection screen of the Control Panel, press ◀ or ▶ to select the Settings/Adj. tab (
Note
• If the Tab Selection screen is not displayed, press the Menu button.
2.
Press the OK button.
The Set./Adj. Menu is displayed.
3.
Press ▲ or ▼ to select Interface Setup, and then press the OK button.
4.
Press ▲ or ▼ to select AppleTalk, and then press the OK button.
5.
Press ▲ or ▼ to select On, and then press the OK button.
6.
Press the Menu button.
If any of the settings is changed, a confirmation message is displayed. In this case, press the OK button.
Important
• Be sure to complete step 6. This will activate the values you have entered.
iPF750
Network Setting > Mac OS X Settings
Configuring the Destination for AppleTalk Networks
>
).
9
723