Zenith L26W56SA Installation And Operating Manual page 9

Connect an o_-air antenna to the LCD Pv'/Honitor.
Locate the Antenna/Cabte jack on the back
of the LCDTV!Monitor,
Connect the antenna wire (FLat or Round)
that runs from the wat[ to this jack,
according to one of the diagrams shown to
the fight.
After at[ connections are comptete, plug in
the TVI The LCD W/Monitor is designed to
operate on AC power.
-p
€
Connections Pane_
If the antenna _s a 75 ohm RF cable, then no
adapters are required.
A 300 to 75 ohm adapter is not included with
the Zenith LCD TV/_4onitor.
F[_ Wire
(300 ohm)
Co_nectioD_s Panel
RF (:oax_a[ Wi_e
(75 ohm)
75 OHM RF CABLE
3OO TO 75 OHM
ADAPTER
The wire that comes from an off-air antenna or cable ser_,ice providen Each end looks like a hex shaped nut with a wire sticking
through the middle,and itscrewsonto the threaded jackon the back of the TV.
A sma[_ de_ce that ¢onne_:ts a two. wke 300 ohm antenna to a 75 ohm RF jack. They am us_Uy about an inch long with two screws
on oT1eend and a round opening with a wire sticking out on the otker end.
PAGE
9