Zenith L26W56SA Installation And Operating Manual page 38

Following is the Commerciat Mode Operation Setup.
Operating Ins_|[er Menu
To set up the controls for the TV you will need to know how to enter
the L26W56XA Insta|ler menu and make changes to the default values
as required. If necessa_, familiarize yourself with the L26W56XA
Installer menu and how to make and save changes in the menu,
r
Op_ona| Instat[er Remote
You wit| need an Instat|er remote control similar to the one
shown to the right,
The TV's c[onable features need to be set up before 25°5 + Menu isdone.
This is a cfitica| step.
If the Master TV display panel's c[onab[e features |ike: Clock Set, adding channel
icons and channe| [abels, etc_ are not done properly, then the c|oned L26W58X TVs
will all have problems. For example, do not do 2°5°5 + Menu more than once or the
TV setup will become corrupted, If you need to start the procedure over, then begin
by setting installer item 117 to 001, and pressing Enter to reset the TV to default
values in the installer menu. You can do 2-5_4 + Menu mode more than once but
this mode is limited to only editing channel icons and channel labels.
Refer to the appropriate section in the Manual for other TVfeatures: Pi_ure, Sound
etc.
J
Typical InstaL|er Menu
LT2002 Clone Programmer
As the cloning procedure is being performed, specific steps need to
be done at the indicated times to achieve the desired result, Be sum to do each
cloning task as indicated. If a procedure or step is left out or not
.............................................................. performed corre_ly, then the TV
setup will be wrong and cloning may not
work, At each step, pay a_ention to assure
the TV screen shows the proper message(s)
when cloning, If the message indicated does
_ not appear, there is a problem with that step
...... and cloning may not be successful Cloning is
only possible when the signal source is an
Ana[oo channel, not a digital channel.
QuickSet # Prograrnrner
L 7'2002
PAGE 38