Zenith L26W56SA Installation And Operating Manual page 55

Some quick and easy tips to resolving problems
Symptoms PossibLe Cause(s) PossibLe SoLution(s) See Page(s)
Power
No Power. See troubleshooting FLow chart. 57
Display Panel Picture
No Picture. • DispLay panel is turned off. -Turn TV on.
-Power failure?
Connect Antenna/CabLe signal source to L26W56XA.
-Check connections on L26W56XA.
-lf appLicabLe, connect M.P.I. cable to M.P.1. device.
-Try another channeL.
-Adjust InstaLLer menu settings.
9_11
7 / 9-15
• Antenna/CabLe not connected.
• Connections incorrect.
• M.P.I. not connected.
• Encrypted program.
• Wrong tuning band. 43-48
Erratic Operation
InstaLLer menu setup. • Wrong InstaLl_r menu settings. -Adjust InstaLLer menu settings as required. 43-48
• Software problem. Remove TV power cord for 15 seconds.
Remote Control
Remote doesn't work. 19-20 • Remote not in TV mode.
• Not aimed at IR remote sensor.
• Remote too far from TR sensor.
• IR path to lV's receiver obstructed.
• Weak batteries.
• Wrong battery polarity.
• Too much Light in room.
• Wrong InstalLer remote controL.
• Incorrect Bed 1-2 setting.
-Use Mode key to seLect TV; puts remote into L26W56XA mode.
-Point remote at TV's IR receiver on TV.
-Move remote closer to Tl/'s IR receiver or darken room.
-Remove obstructions.
-Replace batteries.
-Check that "+" and "-" match in battery compartment.
-Dim room Light.
-Requires compatible InstaLler remote, contact your LG dealer.
-Set correct Bed 1-2 setting.
38
19
Picture Reception
Normal picture, poor • Audio muted. -Press MUTE or use VoLume Up key to increase sound LeveL. 19-20
or no sound. • Broadcast problem. -Try a different channeL. 19-20
Broadcast Tuning Mode Digital Channel OSD
No Information • Item 103 set to 1 - Set Item 103 to 0 for information to be added to virtual 44_48
avaiLabLe display, physicaL channels tuning, channel Luning digital OSD.
*Note: For other problems not caused by the L26W56XA, refer to other devices' operating guide.
PAGE 55