Playback; Normal Playback; Tracking Adjustment; Picture Search - Zenith TVSC1320 Operating Manual & Warranty

Make sure:
• TVNCR power must be turned on.
PLAYBACK
If the erase-protection tab has been removed, the
TV/VCR will start playback automaticalry.
2) Press it again and the TV/VCR will now search
in super high speed (in the LP / SLP modes
only).
NOTE: Tapes recorded in the SP or LP mode
wirl display a noise bar on the TV screen and
the picture may appear in Black and White.
This is normal.
3) Press the PLAY button to return to normal speed.
Press the PLAY button.
Press the STOP button
when playback is completed.
• Tracking adjustment will be set automatically
(Digital Tracking function) when you start
playback.
• However when playing prerecorded tapes or
tapes recorded on units other than your own,
noise lines (black and white streaks) may
appear on the playback picture. If this occurs,
you can adjust the tracking control manually by
pressing the CHANNEL UP or DOWN button
until the streaks disappear. To return to the DTR
function, stop the tape once and start playback
again.
You can view a still picture on the TV (Still mode)
screen during playback. Press the PAUSE/STILL
button during playback. Tapes recorded in the
SLP mode will show the least amount of lines.
Press the PLAY button to return to playback.
NOTE:
• Usually there will be video "noise" lines (black
and white streaks or dots) on the screen. This
is normal.
If the tape was originally recorded in SP or LP
mode, the still picture will be black and white in
addition to the "noise" lines.
This is not a fault of the machine, but
merely a by-product of the technology
involved in producing a TV/VCR with 2
video heads.
• If it is left in the Pause mode for more than five
minutes, the TV/VCR will automatically switch
to the Stop mode.
This feature allows you to reposition or reduce the
noise lines of a still picture.
Press the PAUSE/STILL button so that the noise
lines change position on the screen and you can
see the picture in its entirety without distracting
noise lines.
NOTE: This feature can be activated ONLY when
viewing a tape recorded in the SLP mode. If the
tape was originally recorded in the SP or LP mode,
the still picture may appear in black and white in
addition to the "noise bars". This is normal.
This feature is very useful in finding or skipping
over a particular scene on a tape. In this mode,
the sound will be muted.
1) You may view a video tape at a high speed in
either a forward or reverse direction by
pressing the EFWD or REW button. (in the SP
/ LP / SLP modes).
In the Pause/Still mode only, when the picture
begins to vibrate vertically, stabilize the picture by
pressing the CHANNEL UPor DOWN button.
NOTE: If there are video noise lines on the
screen, reposition or reduce them. Refer to
"Noise line Reduction".
- 22 - EN
9K16