Preparation For Use; Antenna/Cable Connections - Zenith TVSC1320 Operating Manual & Warranty

PREPARATION FOR USE
VHF/UHF COMBINED ANTENNA
The VHF/UHF Dipole Antenna (supplied) is
detachable. Insert the stem of the antenna into
the hole on the upper-back portion of the
TVNCR.
Connect the VHF/UHF Dipole Antenna or
VHF/UHF Combination Antenna to the Antenna
terminal of the TV/VCR as shown in the diagram
below.
For the best reception, fully extend the VHF/UHF
Dipole Antenna and make the necessary
adjustments. (Avoid touching the top section
when adjusting.)
VHF/UHF Antenna (Not supplied)
Antenna ....
(Supplied)
_ Matching
Adapter
(Supplied)
NOTE:
The connection of an indoor antenna may not
always give acceptable TV reception.
VHF/UHF OUTDOOR ANTENNAS
In some areas it will be necessary to use an
outdoor antenna. If you have separate UHF and
VHF antennas, you will need a VHF/UHF
combiner (not supplied) to make the connection
to the Antenna terminal of the TV/VCR. If you
have a VHF/UHF 75 ohm combination antenna,
you can make the connection to the Antenna
terminal of the TV/VCR without needing a
VHF/UHF combiner.
VHF Antenna (Not supplied)
UHF
__ Antenna
_-_ (Not supplied)
(Not
supplied)
I
B ....
Flat twin-lead cable
;ABLE W!THOi " "-',,""_\':., R-_''"',
3_oCRAk, BL_.,_,
If your cable system does not require a converter
box, simply connect the 75 ohm coaxial cable (not
supplied) from the cable system wall outlet to the
Antenna terminal of your TV/VCR.
From Cable System
75-ohm Coaxial
Cable (Not
supplied)
Illllll U }__ll_llll I
_rr_ L t r,
Note to CATV system installer:
This reminder is provided to call the CATV system installer's attention to Article 820-40 of the NEC
that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall
be connected to the grounding system of the building as close to the point of cable entry as
practical.
- 11 - EN
9K16