Hardware Status Icons On Command Center [Device] Tab - Kyocera TASKalfa 650c Troubleshooting Manual

7 CHECKING THE EQUIPMENT STATUS WITH COMMAND CENTER

Hardware Status Icons on COMMAND CENTER [Device] Tab

When the equipment requires maintenance or when an error occurs with the equipment, the icons indicating the status
information appear near the graphic image of the equipment on the COMMAND CENTER [Device] tab. The following are
the icons to appear and the descriptions for them.
For details of the [Device] tab of COMMAND CENTER, refer to the COMMAND CENTER Guide.
Printer Error 1
This icon indicates a non-recommended toner cartridge is used and the equipment stopped printing.
P.47 "Replacing a Toner Cartridge"
Printer Error 2
This icon indicates:
You need to remove paper from the receiving tray of the equipment.
You need to remove paper from the receiving tray of the Finisher.
You need to remove the staples jammed in the Finisher.
P.43 "Staple jam in the Finisher"
You need to remove the staples jammed in the Saddle Stitch unit.
P.44 "Staple jam in the Saddle Stitch unit"
You need to clear the hole punch paper bits from the Hole Punch Unit.
P.58 "Cleaning the Hole Punch Dust Bin"
The recommended toner cartridge is not being used.
P.47 "Replacing a Toner Cartridge"
You tried to perform saddle stitching for a printing on mixed paper sizes.
The equipment cannot load paper from the External Large Capacity Feeder.
Cover Open
This icon indicates the front cover is open.
Toner Empty
This icon indicates no toner is left. It also indicates which color is empty:
P.47 "Replacing a Toner Cartridge"
Waste Toner Full
This icon indicates the waste toner box is full and requires replacing.
P.52 "Replacing the Waste Toner Box"
90

Hardware Status Icons on COMMAND CENTER [Device] Tab