Kyocera TASKalfa 650c Troubleshooting Manual page 12

1 TROUBLESHOOTING FOR THE HARDWARE
Message
Check paper size setting on touch
panel for Bypass tray
Set the paper on the bypass tray
again.
Reboot the machine
Toner near Empty (***)
Confirm waste toner box is attached
and close waste toner box cover
Dispose of used toner
Please Empty Hole Punch Waste
Not enough Work Space to store
originals
Will you print out stored originals?
The number of originals exceeds the
limits. Will you copy stored originals?
Error Codes
The error codes indicating the status of the equipment may appear on the touch panel. You can find the listings of these
codes in Chapter 7.
P.96 "Error Codes"
10 Messages Displayed on the Touch Panel
Problem Description
Paper jam occurred because of a
mismatch between the paper size
placed in the bypass tray and the size
registered for the bypass tray in the
equipment.
The paper placed on the bypass tray
jammed.
An error occurred in the equipment
and it stopped normal operation.
A toner is running out. "***" indicates
the color.
(The colors are shown in
abbreviations when two or more
toners are running out: Y: yellow,
M:magenta, C:cyan, and K:black)
The waste toner box is not securely
attached or the waste toner box cover
is open.
The waste toner box is full.
The Hole Punch Unit dust bin is full.
Internal memory available ran out
while scanning.
The number of images scanned
exceeded the maximum (about 1000
in A4 or LT).
Solution
Register the paper size correctly. Just clearing the
paper jam does not prevent another paper jam.
P.33 "Clearing paper jams caused by a wrong
paper size setting"
Remove the jammed paper and set the paper again.
Rebooting the equipment may correct the error. To
reboot the equipment, turn the main power switch off
and then on.
Check the color of the toner on the touch panel and
prepare the toner cartridge.
(About 4000 copies more can be made after this
message appears.)
Replace a toner cartridge after the message
"Install new *** toner cartridge" is displayed.
Black and white printing is available while the
other colors have run out. Neither color nor
black and white printing can be done when
the black toner has run out.
If you replace a toner cartridge with a new one
while some toner remains, make sure to clear
the counter. This is necessary for the
equipment to display the next "Toner near
Empty" message at the proper time. For the
procedure, see below.
P.49 "Replacing a "Near Empty" toner
cartridge"
Confirm the waste toner box is securely mounted and
close the waste toner box cover.
P.52 "Replacing the Waste Toner Box"
Replace the waste toner box following the guidance
displayed on the touch panel.
P.52 "Replacing the Waste Toner Box"
Remove the paper punchings.
P.58 "Cleaning the Hole Punch Dust Bin"
To print out the data for the originals stored (scanned)
until the message appeared, press [YES] on the touch
panel. To delete the stored data, press [NO].
To print out the data for the originals stored (scanned)
until the message appeared, press [YES] on the touch
panel. To delete the stored data, press [NO].