Table of Contents
Advertisement
INSTALLATION CODES AND STANDARDS
The tilting skillet must be installed in accordance with:
In the United States of America:
1. State and local codes.
2. National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The
National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
In Canada:
1. Local codes.
2. Canadian Electrical Code, Part 2, CSA Standard C22.1 (latest edition). Copies may be obtained
from The Canadian Standard Association, 178 Rexdale Blvd., Rexdale, Ontario, Canada M9W1R3.
LEVELING AND ANCHORING TILTING SKILLET
The tilting skillet must be anchored to the floor.
1. Place skillet in the installation position.
2. Place a carpenter's level on top of the skillet and turn the adjustable feet to level the skillet side to
side and front to back.
3. Mark hole locations on the floor through the anchoring holes provided in the rear flanged adjustable
feet. See diagram on page 5.
4. Remove skillet from installation position and drill holes in locations marked on the floor. Insert
proper anchoring devices (not supplied).
5. Place skillet back in the installation position.
6. Place carpenter's level on top of skillet and re-level side to side and front to back.
7. Bolt and anchor skillet securely to the floor.
8. Seal bolts and flanged feet with a silicone or equivalent compound.
ELECTRICAL CONNECTIONS
WARNING: ELECTRICAL AND GROUNDING CONNECTIONS MUST COMPLY WITH THE
APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL CODE AND/OR OTHER LOCAL
ELECTRICAL CODES.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH TO INDICATE YOU ARE WORKING ON THE CIRCUIT.
The control box for field wire connection is located at the left side rear when viewed from the front. A
knockout hole is provided for a 1
23
⁄
" (43.6mm) conduit connection.
32
— 4 —
Advertisement
Table of Contents
