Epson FX-1050 User Manual page 149

ESC EM
Format:
ASCII code:
Decimal :
Hexadecimal:
Comments:
The following values can be used for n:
4: Mode is turned ON.
0: Mode is turned OFF.
The variables are the characters "0" (48 decimal) and "4" (52 decimal).
The command should not be used unless the cut sheet feeder is
installed. It is ignored if any value other than "0" or "4" is used for n.
The mode can also be turned on or off with DIP switch 2-2.
MSB control
Note: MSB is the Most Significant Bit.
and ESC #) is not valid for graphics or user-defined characters.
ESC = (equal)
Format:
ASCII code:
Decimal:
H e x a d e c i m a l :
Comments:
Sets the MSB of all incoming data to 0. Some computers always send
data with the MSB set to
graphics are always printed. ESC = can overcome this problem.
Command Summary
ESC EM
27 25
1B 19
ESC =
27 61
1B 3D
which means that italics or character
1,
Turn Cut Sheet Feeder Mode On/Off
n
n
n
MSB control (ESC =, ESC>,
Set MSB to 0
8-11