Switching From The Cut Sheet Feeder To Continuous Paper - Epson FX-1050 User Manual

Below is a portion of the first page of a self test in cut sheet feeder mode.
The remainder of the self test is similar to the original self test described
in Chapter 1.
WARNING: Never perform

Switching from the cut sheet feeder to continuous paper

The FX allows you to switch between cut sheet feeder paper and
continuous paper easily without having to remove either the feeder or
the continuous paper supply. To switch between these two paper feeding
methods, follow the steps below.
1. Make sure the continuous paper is already loaded and in a standby
position, as explained in the section on switching between single
sheets and continuous paper in Chapter 2.
2. Install the cut sheet feeder as described in this section, making sure
that DIP switch 2-2 is set to on, and that the paper release lever is
pushed all the way back to the single sheet position.
7-12
the self test on envelopes.
Using Printer Options