Onchip Sata Controller - Gigabyte GA-E240N User Manual

& OnChip SATA Controller
Enables or disables the integrated SATA controllers. (Default: Enabled)
& OnChip SATA Type
Configures the operating mode of the integrated SATA controller.
Native IDE Allows the SATA controllers to operate in Native IDE mode. Enabled Native IDE mode
if you wish to install operating systems that support Native mode. (Default)
AHCI C onfigures the SATA controller to AHCI mode. Advanced Host Controller Interface
(AHCI) is an interface specification that allows the storage driver to enable advanced
Serial ATA features such as Native Command Queuing and hot plug.
& OnChip SATA Port as ESP
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Port0 as ESP
Port1 as ESP
Port2 as ESP
Port3 as ESP
: Move Enter: Select
F5: Previous Values
& Port0 as ESP/Port1 as ESP/Port2 as ESP/Port3 as ESP
This option is configurable only when OnChip SATA Type is set to AHCI. Enabled will speed up the hot
plug detection of the connected SATA device. (Default: Disabled)
& Onboard LAN Function
Enables or disables the onboard LAN function. (Default: Enabled)
If you wish to install a 3rd party add-in network card instead of using the onboard LAN, set this item to
Disabled.
& Onboard LAN Boot ROM
Allows you to decide whether to activate the boot ROM integrated with the onboard LAN chip. (Default:
Disabled)
& SMART LAN (LAN Cable Diagnostic Function)
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
Start detecting at Port.....
Part1-2 Status = Open / Length =
Part3-6 Status = Open / Length =
Part4-5 Status = Open / Length =
Part7-8 Status = Open / Length =
: Move Enter: Select
F5: Previous Values
This motherboard incorporates cable diagnostic feature designed to detect the status of the attached LAN cable.
This feature will detect cabling issue and report the approximate distance to the fault or short.
OnChip SATA Port as ESP
[Disabled]
[Disabled]
[Disabled]
[Disabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
SMART LAN
0m
0m
0m
0m
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 29 -
Item Help
Menu Level ``
ESC: Exit F1: General Help
F7: Optimized Defaults
Item Help
Menu Level ``
ESC: Exit F1: General Help
F7: Optimized Defaults