Memory Clock - Gigabyte GA-E240N User Manual

& CPU Frequency(MHz)
Allows you to manually set the CPU host frequency. Options are 1500MHz. (Default: Normal)
& CPU Host Clock Control
Enables or disables the control of CPU host clock. Auto (default) allows the BIOS to automatically adjust
the CPU host frequency. Manual allows the CPU Frequency (MHz) item below to be configurable.
Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow for automated
system reboot, or clear the CMOS values to reset the board to default values. (Default: Auto)
& CPU Host Clock
Allows you to manually set the CPU host clock. The adjustable range is from 100 MHz to 120 MHz. This
item is configurable only when CPU Host Clock Control is set to Manual.
& Set Memory Clock
Determines whether to manually set the memory clock. Manual allows the memory clock control item
below to be configurable. Auto lets BIOS automatically set the memory clock as required. Manual allows
the memory clock control item below to be configurable. (Default: Auto)
& Memory Clock
This option is configurable only when Set Memory Clock is set to Manual. Options are: X5.33, X6.66.
& DRAM Configuration
CMOS Setup Utility-Copyright (C) 1984-2012 Award Software
DDR3 Timing Items
x 1T/2T Command Timing
x CAS# latency
x RAS to CAS R/W Delay
x Row Precharge Time
x Minimum RAS Active Time
x TwTr Command Delay
x Trfc0 for DIMM1
x Trfc1 for DIMM2
x Write Recovery Time
x Precharge Time
x Row Cycle Time
x RAS to RAS Delay
x Four Bank Activate Window
Bank Interleaving
: Move Enter: Select
F5: Previous Values
& DDR3 Timing Items
Manual allows all DRAM timing control items below to be configurable.
Options are: Auto (default), Manual.
& 1T/2T Command Timing
Options are: Auto (default), 1T, 2T.
& CAS# latency
Options are: Auto (default), 5T~14T.
& RAS to CAS R/W Delay
Options are: Auto (default), 5T~14T.
DRAM Configuration
[Auto] SPD Auto
Auto -- --
Auto 9T 8T
Auto 9T 8T
Auto 9T 8T
Auto 24T 20T
Auto 5T 4T
Auto 110ns 110ns
Auto -- --
Auto 10T 8T
Auto 5T 4T
Auto 33T 27T
Auto 4T 4T
Auto -- --
[Enabled]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
- 24 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults