Configuring Marvell ® 88Se9230 Sata Controller - Gigabyte G1.Sniper 5 User Manual

3-2 Configuring Marvell
A. Installing SATA hard drive(s) in your computer
Attach one end of the SATA signal cable to the rear of the SATA hard drive and the other end to available
SATA port on the motherboard. The Marvell
connectors. Then connect the power connector from your power supply to the hard drive.
B. Configuring SATA controller and RAID mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST. To create RAID, go to
Peripherals\Marvell ATA Controller Configuration and make sure GSATA Controller is set to AHCI Mode.
Press <Enter> on GSATA RAID Configuration to enter the RAID configuration screen.
The BIOS Setup menus described in this section may differ from the exact settings for your motherboard.
The actual BIOS Setup menu options you will see shall depend on the motherboard you have and
the BIOS version.
88SE9230 SATA Controller
®
88SE9230 SATA controller controls the onboard GSATA3 6/7/8/9
®
Figure 1
- 73 - Configuring SATA Hard Drive(s)