Table of Contents
Advertisement
_._ Hold-the Butteflly -Top Frame-(64) and the Press Top
Fr._r:ne(63)-on the indicated brab'kets on" the Uprights
(59, 62) and the Weight Guides (58)• Note: Before
attaching
the Top Frames to the Uprights,
make
sure that both Weight Guides (58) are positioned
inside of the indicated holes.
Attach the Butterfly Top Frame (64) and the Press
Top Frame (63) to the Uprights (59, 62) and Weight
Guides (58) with four 5/16" x 2. 3/4" Bolts (20), two
Top Plates (46), and four 5/16" Nylon Locknuts (2).
Do not tighten the Nylon Locknuts yet.
Secure the Weight Guides (58) to the Butterfly Top
Frame (64) and to the Press Top Frame (63) with two
3/8" x 2 1/2" Bolts (6), four 3/8" Flat Washers (17),
and two 3/8" Jam Nuts (18).
6
2O
io
62 f
58--<
-----.
_',
r.
_o'1
O
_-_2
_,.__.
59_
7,
Turn the Seat Brace (75) so the nut is on the side as
shown. Attach the Seat Brace (75) to the Butterfly
Base (61) with the 5/16" x 2 1/2" Carriage Bolts (1)
and two 5/16" Nylon Locknuts (2). Do not tighten
the
Nylon Locknuts yet.
7
61
8.
Hold the Seat Bar (74) between the Seat Brace (75)
and the Butterfly Upright (62) so that the hole that is
closest to the welded plate is facing the Seat Brace.
Attach the Seat Bar (74) to the Seat Brace (75) with
two 5/16" x 2 1/2" Bolts (3), two 5/16" Flat Washers
(19), and two 5/16" Nylon Locknuts (2). Do not over-
Ugten the Bolts or the Curl Post attached
in step
38 will not slide freely. Do not tighten the Nylon
Locknuts yet.
Attach the Seat Bar (74) to the Butterfly Upright (62)
with two 5/16" x 2 1/2" Bolts (3), two 5/16" Flat
Washers (19), and two 5/16" Nylon Locknuts (2).
Important:
Go back and tighten all of the Nylon
Locknuts used in steps 1 through 8.
Hole
/_]
}'l
] o_._3
74 /
" / !
ii 6ii
'1°
8
Hide quick links:
Advertisement
Table of Contents
