Weider PRO 9930 User Manual page 7

" "3.-'Place _vo'_/e!ghi Burn'pers (8_ over'the indicated -"
holes in the Butterfly Base (61). Slide the Weight
Guides (58) into the indicated holes.
Attach the Weight Guides (58) to the Butt_;iy Base
(61) with two 3/8" x 2 1/2" Bolts (6), four 3/8" Flat
Washers (17), and two 3/8" Jam Nuts (18).
Slide the eight Weights (8) onto the Weight Guides
(58). Make sure the Weights are turned so the pin
grooves are on the bottom of the weights.
3
Pin
61
6
58
4.
5°
Press a Weight Tube Bumper (76) into tiie lower end
of the Weight Tube (77). Slide the Weight Tube into
the center hole in the Weights (8).
Lubricate the holes in the Top Weight (78). Slide the
Top Weight onto the Weight Guides (58).
Press a 2" Square Inner Cap (38) into the Butterfly
Top Frame (64). Press two 1" Round Inner Caps (41)
into the top of the Butterfly Top Frame.
Attach the Butterfly Top Frame (64) to the Press Top
Frame (63) with two 5/16" x 2 1/2" Bolts (3), two 5/16"
Flat Washers (19), and two 5/16" Nylon Locknuts (2).
Press a 2" Square Inner Caps (38) into the end of the
Press Top Frame (63).
4
Lubricate
!! °
n
_ o
41 64
38
2
\
2
/38
63
7