Checking The Needle Drop Point With The Embroidery Foot "W+" With Led Pointer - Brother DreamWeaver„ XE VM6200D Operation Manual

BEFORE EMBROIDERING
g
Hold the embroidery foot in place with
your right hand, and then use the included
screwdriver to securely tighten the presser
foot holder screw.
CAUTION
• Use the included screwdriver to firmly tighten
the screw of the embroidery foot. If the screw
is loose, the needle may strike the presser foot
and possibly cause injury.
h
Plug the connector of the embroidery foot
"W+" with LED pointer into the jack on the
back of your machine.
i
Press to unlock all keys and
buttons.
→ All keys and operation buttons are unlocked, and
the previous screen is displayed.
B-62
■ Checking the Needle Drop Point
With the Embroidery Foot "W+"
with LED Pointer
Before beginning to embroider when using the
embroidery foot "W+" with LED pointer, carefully
read the procedures described in the "Embroidery"
and "Embroidery Edit" chapters.
a
Press in the embroidery screen.
→ The LED pointer indicates the needle drop point.
Memo
• When the LED pointer is turned on, the
presser foot height is automatically adjusted
according to the fabric thickness.
• If is pressed again, the fabric thickness
is remeasured and the presser foot is set to
the optimum height.
* The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.
Note
• With thick elastic fabric, the position will be
misaligned only at raised parts in the fabric.
In this case, manually adjust the position
according to the thickness of the fabric.
• With fabric that has a very uneven surface
such as quilting, the position is not correctly
aligned. In this case, the pointer indication
should be used only as a reference.