Brother DreamWeaver„ XE VM6200D Operation Manual page 315

Marks
OK to delete the selected pattern?
OK to delete the selected picture?
OK to delete the setting?
OK to recall and resume previous memory?
OK to reset the pattern's border setting, position and/or angle? This message appears when you try to use the automatic
OK to revert to the original position and/or angle?
Preventive maintenance is recommended.
Raise the buttonhole lever.
Remove Dual Feed module from the machine.
Remove Embroidery foot with LED pointer from the machine.
Retrieving the pattern. Wait a moment.
Sensor module error.
Set the clock.
The bobbin thread is almost empty.
The bobbin winder safety device has activated. Is the thread
tangled?
The carriage of the embroidery unit will move. Keep your
hands etc. away from the carriage.
The ending point cannot be selected for this stitch.
The needle position cannot be changed for this stitch.
The needle will move. Keep your hands etc. away from the
needle area.
Error Messages Cause/Solution
This message is displayed when, after selecting a pattern,
or is pressed and the pattern is about to be
deleted.
This message is displayed when the image is deleted.
This message appears when
delete the settings for a utility stitch. To delete the selected
settings, press .
This message appears if the machine is turned off while
sewing, then turned on again.
Press to return the machine to the condition (pattern
position and number of stitches) when it was turned off. Follow
the procedure described in "If the Thread Breaks During
Sewing" on page E-27 to align the needle position and sew the
remainder of the pattern.
positioning function using the sensor pen with the pattern,
rotated or replaced, or with the border pattern. (see page B-83)
This message appears when you try to use the automatic
positioning function using the sensor pen with the pattern,
rotated or replaced. (see page B-83)
This message is displayed when the machine needs to be
maintained. (see page A-19)
This message is displayed when the buttonhole lever is down,
a stitch other than a buttonhole is selected, and the
"Start/Stop" button or the "Reverse Stitch" button is pushed.
This message appears when you try to start embroidering with
the dual feed foot attached to the machine. Remove the dual
feed foot before entering the embroidery mode. (see page
B-68)
This message appears when you try to start sewing
utility/decorative stitch or character pattern with the
embroidery foot with the LED pointer attached to the machine.
Remove the embroidery foot with the LED pointer before
entering the sewing mode. (see page B-61)
This message is displayed when the machine is retrieving a
previously saved pattern while in "Embroidery Edit" mode.
This message appears when something is wrong with the
sensor unit of the machine. Consult your authorized dealer.
This message appears when the time/date is not set. Set
time/date. (see page B-22)
This message is displayed when the bobbin thread is running
out.
This message is displayed when the bobbin is being wound,
and the motor locks because the thread is tangled, etc.
This message appears before embroidery unit moves.
This message appears when the function to specify the sewing
end point cannot be used with the current stitch. Select other
stitch. (see page B-81)
This message appears when the function to specify the needle
drop position cannot be used with the current stitch. Select
other stitch. (see page B-81)
This message appears when you touch the point closer than 2
cm from the needle drop point with the sensor pen in the
sensor function. (see page B-73)
ERROR MESSAGES
A
2
or is pressed to
Appendix A-35