Error Messages - Brother DreamWeaver„ XE VM6200D Operation Manual

ERROR MESSAGES

ERROR MESSAGES

If the machine is not properly set and the "Start/Stop" button or the "Reverse Stitch" button is pressed, or
if the operation procedure is incorrect, the machine does not start. An alarm sounds and an error message
is displayed on the LCD. If an error message displays, follow the instructions in the message.
Below is an explanation of error messages. Refer to these when necessary (if you press
operation correctly while the error message is displayed, the message disappears).
• Be sure to rethread the machine. If you press the "Start/Stop" button without rethreading the machine,
the thread tension may be wrong or the needle may break and cause injury.
Marks
A malfunction occurred.Turn the machine off, then on again.
An invalid area was touched by the sensor pen. Touch again
within the active sensor area. (130mm x 200mm / 5"X 8")
An invalid sewing area was touched by the sensor pen. Touch
again within the valid sewing area.
Attach the embroidery frame.
Can not change the configuration of the characters
Check and rethread the upper thread.
Data volume is too large for this pattern.
Failed to save file.
In twin needle mode, the automatic needle threading button
cannot be used.
Lower the buttonhole lever.
Lower the presser foot lever.
Move the sensor pen away from the currently marked position. This message appears when you press down the sensor pen
Not enough available memory to save the pattern. Delete
another pattern?
OK to automatically lower the presser foot?
OK to delete the ending point setting?
A-34
CAUTION
Error Messages Cause/Solution
This message is displayed if some malfunction occurs.
This message appears when you touch the invalid area of
sensor pen. Touch the active area. (see page B-76)
This message appears when you touch the invalid area of
sewing with the sensor pen. Touch the active area. (see page
B-76)
This message appears if the embroidery frame is not attached
when you press in the embroidery screen. (see page
B-83)
This message is displayed when there are too many characters
and the curved character configuration is impossible.
This message is displayed when the upper thread is broken or
not threaded correctly, and the "Start/Stop" button or the
"Reverse Stitch" button is pressed.
This message is displayed when the patterns you are editing
take up too much memory, or if you are editing too many
patterns for the memory.
This message appears when you try to save more than 100
settings screen image files in the USB media. In this case,
delete a file from the USB media or use different USB media.
(see page B-35)
This message is displayed when the automatic needle
threading button is pushed while twin needle sewing is set.
This message is displayed when the buttonhole lever is up, a
buttonhole stitch is selected, and the "Start/Stop" button or
"Reverse Stitch" button is pushed.
This message is displayed when the "Presser Foot Lifter"
button is pushed while the presser foot lever is raised/the
needle is lowered.
tip before pressing and keep pressing for the certain
period. Move the sensor pen away from the current position.
This message is displayed when the memory is full and the
stitch or pattern cannot be saved.
This message is displayed when
presser foot is raised).
This message appears when you try to recall the pattern
stored in the machine while specifying the sewing end point
using the sensor function. (see page B-81)
or do the
is pressed (the