Crazy Quilting; Smocking Stitches - Brother DreamWeaver„ XE VM6200D Operation Manual

c
Trim along the seam, making sure not to cut
the stitches.
Memo
• Use a seam sealant to secure the edges of
the scallop stitches.

Crazy Quilting

For a decorative look called "Crazy Quilting", the
following stitches can be sewn on top of a pressed
seam allowance.
a
Select a straight stitch and attach presser
foot "J".
b
With the right sides facing each other, sew
two pieces of fabric together, and then
press open the seam allowance.
a Straight stitch
b Seam margins
c 6.5 mm (approx. 1/4 inch)
d Wrong side
c
Select a stitch for top stitching.
d
Place the fabric right side up in the
machine, and center the presser foot over
the seam when sewing.
a Right side of fabric

Smocking Stitches

Use smocking stitches for decorative sewing on
clothes, etc.
a
Select a straight stitch and attach presser
foot "J".
b
Set the stitch length to 4.0 mm (approx.
3/16 inch) and loosen the upper thread
tension to approximately 2.0 (see "Setting
the Stitch Length" on page S-10 and
"Setting the Thread Tension" on page S-12).
c
Pull the bobbin and upper threads out by
50 mm (approx. 1-15/16 inches).
d
Sew the seams, leaving approximately
10 mm (approx. 3/8 inch) between the
seams, then trim excess thread, leaving
50 mm (approx. 1-15/16 inches).
a Approximately 10 mm (approx. 3/8 inch)
SEWING THE STITCHES
Sewing S-45
S
2