Brother DreamWeaver„ XE VM6200D Operation Manual page 288

PREPARING FOR BOBBIN WORK
p
Install the needle plate cover and bobbin
cover with tabs.
For details on installing the needle plate cover, refer to
"Cleaning the Race" on page A-19.
a Bobbin cover
b Bobbin cover with tabs
CAUTION
• When creating bobbin work, use the bobbin
cover with tabs, otherwise the thread may
become tangled or the needle may break.
Note
• When installing the needle plate cover, do
not allow it to pinch the thread.
q
Install the flat bed attachment or
embroidery unit.
Note
• When installing the flat bed attachment or
embroidery unit, do not allow it to pinch the
thread.
• When the bobbin thread is replaced with a
new one, be sure to repeat the procedure
a
from , otherwise the lower threading will
not be done correctly.
→ This completes the upper and lower threading.
Note
• If utility stitches are to be used, refer to
"CREATING BOBBIN WORK (SEWING)" on
page A-9. If embroidery patterns are to be
used, refer to "CREATING BOBBIN WORK
(EMBROIDERY)" on page A-12.
A-8