Table of Contents
Advertisement
Removing the Embroidery Frame
a
Press
(Presser foot lifter button) to raise the
presser foot.
b
Raise the frame-securing lever.
c
Pull the embroidery frame toward you.
CONFIRMING THE PATTERN POSITION
CONFIRMING THE PATTERN
POSITION
The pattern is normally positioned in the center of the
embroidery frame. If the pattern needs to be repositioned
for better placement on the garment, you can check the
layout before starting embroidery.
Checking the Needle Drop Point with the
Embroidery Foot "W+" with LED Pointer
a
Touch
in the embroidery screen.
The LED pointer indicates the needle drop point.
Memo
• When the LED pointer turns on, the presser foot
height is automatically adjusted according to the
fabric thickness.
•
appears when the embroidery foot "W+" with
LED pointer is attached to the machine.
• If
is not displayed, you cannot use the LED
pointer.
• The LED pointer turns off automatically by lowering
the presser foot or returning to the previous page.
Note
• With spongy fabric, the position may not be
accurate due to the various depths of the fabric.
• With fabric that has a very uneven surface such as
quilting, the fabric thickness may not be correctly
measured. In this case, the pointer indication
should be used only as a reference.
Adjusting the LED Pointer
Adjust the LED pointer if it indicates a point different than
the actual needle drop point. Before adjusting the LED
pointer, mark the actual needle drop point on the fabric to
be embroidered, and attach the embroidery frame.
a
Touch
.
The settings screen appears.
b
Touch
.
The embroidery settings screen appears.
2
57
Advertisement
Table of Contents
