4 Replacement Procedures
Removing the RTC Battery
Remove the RTC battery according to the following procedures and Figure 4-21.
1. Disconnect the RTC battery cable from the RTC battery connector on the system
board.
2. Take the RTC battery out of the battery tray.
Installing the RTC Battery
Install the RTC battery according to the following procedures and Figure 4-21.
1. Connect the RTC battery cable to the RTC battery connector on the system board.
2. Place the RTC battery in the correct position.
4-36
Figure 4-21 Removing the RTC battery
4.7 RTC Battery
TECRA S1 Maintenance Manual