Disassembling The Touch Pad - Toshiba TECRA S1 Maintenance Manual

4.6 Touch Pad

Disassembling the Touch Pad

NOTE: Do not disassemble the touch pad when it is working normally. Disassemble or
replace the touch pad only if it failed.
Disassemble the touch pad according to the following procedures and figure 4-19 and 4-20.
1. Disconnect the touch pad cable from CN1.
2. Remove the two M2x3 white flat-head screws.
3. Remove the touch pad holder by sliding it in the direction of the arrow.
4. Release the two latches on the touch pad cover.
TECRA S1 Maintenance Manual
Figure 4-19 Removing the touch pad holder
Figure 4-20 Removing the touch pad cover
4 Replacement Procedures
4-33