Switches at Machine Heads
BES-963BC
START
Stop switch
Stops embroidering operation. "Release stop SW to operate!" is displayed on
the screen as soon as the machine stops.
Refer to "Resetting Machine Stop" (
Start switch
Starts embroidering. Holding down this switch executes embroidering at a low
speed.
When resuming embroidering after a stop, release stop before pressing this
switch. Refer to "Resetting Machine Stop" (
Switches on Tension Plate
BES-963BC • BES-1263BC
BES-1263BC
Between head No. 1 and No. 2
Between head No. 3 and No. 4
Start switch
Between head No. 5 and No. 6
Stop switch
Between head No. 2 and No. 3
Between head No. 4 and No. 5
page 127) to stop flashing.
THREAD SENSOR lamp
HEAD switch
MENDING lamp
MENDING switch
STEP BACK/FWD switch
Chapter 2 Embroidering Procedures
Stop switch
START
Start switch
page 127) for details.
51