Brother BES-963 Instruction Manual page 41

• By changing the tubular round arm mounting width, various sizes can be set.
Note) Change the width, referring to the pin position.
360mm
500mm
Note) If two pins cannot be inserted, remove one.
• If a tubular round arm has a backlash:
Follow these steps for adjustment:
1. Move the end of the tubular round arm to
Screw q
2. If a clearance is left as shown in the figure,
Tubular round
arm support
*
BES-963BC • BES-1263BC
Chapter 1 Preparation of Embroidery Machine
400mm
600mm
the left.
loosen screw q and adjust the tubular
round arm support so as to eliminate the
clearance between the support and the X-
feed frame. Tighten screw q.
Follow the same steps when moving the
end face of a tubular round arm to the right.
39