Adjustment Of Presser Foot Height - Brother BES-963 Instruction Manual

5. Adjustment of Presser Foot Height

1. Turn the power switch off.
2. Select the needle bar No. 1.
3. Loosen the screw w of the presser foot q, and adjust the presser foot q until it comes
above the cloth top surface when it is at the alignment position (where the pulley B indication
mark " " and the cover indication mark " " are aligned).
Note) When the presser feet have been adjusted in height, check that each needle lowers to the center of the
presser foot hole.
6. After timing adjustment the is finished for
each head, set the pulley B q to the stop
position (at 100˚ of the scale) and press
ESC
state.
The adjustment of the rotary hook is
completed and the timing is stored. The
rotary hook returns to the stop position
accordingly.
BES-963BC • BES-1263BC
. The machine enters the standby
w
q
Chapter 8 Adjustment
material
155