Replacement Of Bobbin - Brother BES-963 Instruction Manual

Chapter 1 Preparation of Embroidery Machine

4-2 Replacement of Bobbin

Note) Remove dust, lint and oil from the bobbin case before replacement.
Removing bobbin case
w
q
Replacing bobbin
t
t
Pull out by about
50 mm
36
e
r
BES-963BC • BES-1263BC
1. Open the rotary hook cover B q.
2. Hold the knob w and take out the bobbin
case.
3. Close the knob and take out the bobbin e.
1. Put a new bobbin in the bobbin case.
Check the winding direction.
Check that the bobbin is pushed out of the bobbin case
by about 0.5 mm. If not, the slip prevention spring of the
bobbin case does not work. Adjust the height of the
spring or replace it with a new one.
Bobbin
2. Slide the thread under the tension spring
t through the notch r.
3. Pull out the thread from the hole of the
tension spring t.
4. Pull out the thread by about 50 mm.
0.5mm