e
w
* Bad example
t
r
• The thread trimmer connecting rod B w
has a backlash of about 0.1 ~ 0.2 mm back
and forth. Tighten the two bolts e while
q
pulling them forward by the backlash
amount.
• Tighten the two bolts e so that the thread
trimmer connecting rods B w and C q
are positioned in a straight line.
Mount head No. 3 so as to make thread
Toward
trimmer connecting rod D r parallel with
this side
the side of the bed.
interference will occur during feed in the
crosswise direction.)
Bed
5. After adjustment is finished, reset the stop
switch.
"Release stop SW to operate!" disappears.
6. Turn the power switch off once, then on
again. Check that the clearance between
the movable knife r and the fixed knife t
is 1 mm.
7. When adjusting again, follow the step 2 and
1mm
after.
BES-963BC • BES-1263BC
Chapter 8 Adjustment
(Check that no
r
157