Adjustment Of Presser Foot Height - Brother BES-962BC Instruction Manual

5. Adjustment of Presser Foot Height

1. Turn the power switch off.
2. Select the needle bar No. 1.
3. Loosen the screw w of the presser foot q, and adjust the presser foot q until it comes
above the cloth top surface when it is at the bottom dead center (where the pulley indication
mark " " and the cover indication mark " " are aligned).
Note) When the presser feet have been adjusted in height, check that each needle lowers to the center of the
presser foot hole.
7. After timing adjustment the is finished for
each head, set the pulley to the stop
position (at 100˚ of the scale) and press the
STOP switch. "STEP" disappears from the
display, and the machine enters the
standby state.
STOP
The adjustment of the rotary hook is
completed and the timing is stored. The
rotary hook returns to the stop position
accordingly.
BES-962BC • BES-1262BC
Chapter 10 Adjustment
w
q
material
239