Gateway E1400 System Manual page 92

Checking the type of power management on your system
ACPI is available only if Windows 98 was installed with ACPI enabled. If
Windows 98 was not installed with ACPI enabled, APM power management
is available.
To check the type of power management on your system:
1
Click
Start
window opens.
2
Double-click
3
Click the
of power management supported appears at the top of the list under
System devices
If you want to enable ACPI in Windows 98, see the Microsoft Web site for
instructions.
Putting your system into Standby (S1)
You can put your system into Standby by clicking
,
Shutdown Standby
Standby with both APM and ACPI.
If ACPI is enabled on your system, you can also set a timer or press the power
button to put your system into Standby.
To set the standby timer:
1
Click
Start
window opens.
2
Double-click the
Properties window opens.
3
On the
when it has been inactive for the amount of time you set.
To set the computer's power button to put the system into Standby:
1
Click
Start
window opens.
2
Double-click the
Properties window opens.
, then select
Settings
. The System Properties window opens.
System
tab, then double-click
Device Manager
.
, then clicking
, then select
Settings
Power Management
tab, set the timer. Your system enters Standby
Power Schemes
, then select
Settings
Power Management
, then
Control Panel
System devices
Start
. This procedure puts your system into
OK
, then
Control Panel
icon. The Power Management
, then
Control Panel
icon. The Power Management
System power management
. The Control Panel
. The type
, then selecting
. The Control Panel
. The Control Panel
85