Gateway E1400 System Manual page 69

c
Lift the heat sink at an angle and unhook the clip from the other
tab. Lift the heat sink off the processor.
4
Remove the processor:
a
Open the locking lever on the processor socket by moving the lever
slightly out to the side and then lifting it up 90 degrees.
Locking
b
Lift the old processor straight up and out of the socket.
5
Install the new processor:
a
Hold the new processor over the empty processor socket and verify
that pin 1 on both the processor and the socket are aligned. Pin
1 is near the cut out corner.
b
Gently place the new processor into the socket.
c
Secure the processor by lowering the locking lever until the lever
latches into place. The processor will slip into place without
pressure when aligned correctly.
62
System Components
lever
Processor
Pin 1