Change Navigation Sources; Enable/Disable Obs Mode While Navigating With Gps; Generic Timer; Configure Vspeed Bugs Individually - Garmin G1000 Cockpit Reference Manual

Flight Instruments
3) Turn the small FMS Knob in the direction of the green arrowhead to select
ON.
4) Press the MENU Key to remove the window.

CHANGE NAVIGATION SOURCES

1) Press the CDI Softkey to change from GPS to VOR1 or LOC1. This places
the light blue tuning box over the NAV1 standby frequency in the upper left
corner of the PFD.
2) Press the CDI Softkey again to change from VOR1 or LOC1 to VOR2
or LOC2. This places the light blue tuning box over the NAV2 standby
frequency.
3) Press the CDI Softkey a third time to return to GPS.

ENABLE/DISABLE OBS MODE WHILE NAVIGATING WITH GPS

1) Press the OBS Softkey to select OBS Mode.
2) Turn a CRS Knob to select the desired course to/from the waypoint. Press a
CRS Knob to synchronize the Selected Course with the bearing to the next
waypoint.
3) Press the OBS Softkey again to disable OBS Mode.

GENERIC TIMER

1) Press the TMR/REF Softkey, then turn the large FMS Knob to select the
time field (hh/mm/ss). Turn the FMS Knobs to set the desired time, then
press the ENT Key. The UP/DOWN field is now highlighted.
2) Turn the small FMS Knob to display the UP/DOWN window. Turn the FMS
Knob to select 'UP' or 'DOWN', then press the ENT Key. 'START?' is now
highlighted.
3) Press the ENT Key to START, STOP, or RESET the timer (if the timer is
counting DOWN, it will start counting UP after reaching zero). Press the
CLR Key or the TMR/REF Softkey to remove the window.
CONFIGURE VSPEED BUGS INDIVIDUALLY
1)
Press the TMR/REF Softkey.
2)
Turn the large FMS Knob to highlight the desired Vspeed.
2
Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang 190-00600-01 Rev. C