Antenna Stabilization - Garmin G1000 Cockpit Reference Manual

Hazard Avoidance
4) Press the FMS Knob to activate the cursor.
5) Turn the large FMS Knob to place the cursor in the 'TILT' field.
6) Adjust the antenna tilt angle by turning the small FMS Knob to position the
ground returns as desired.
7) Press the FMS Knob to remove the cursor.
Ground Map
Mode Color
Sector Scan
1) While in the Horizontal Scan Mode, move the Joystick right or left to place
the Bearing Line in the desired position. The location of the Bearing Line
will become the center point of the Sector Scan.
2) Press the FMS Knob to display the cursor.
3) Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
4) Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
5) If desired, readjust the Bearing Line with the Joystick to change the center
of the Sector Scan.
6) Press the FMS Knob to remove the cursor.

Antenna Stabilization

1) To activate or deactivate the antenna stabilization, select the MODE
Softkey.
2) Select the STAB ON Softkey to activate antenna stabilization or select
the STAB OFF Softkey to deactivate. The current stabilization condition is
shown in the upper right of the weather radar display.
Weather Attenuated Color Highlight (WATCH™)
To activate or deactivate the Watch™ feature, select the WATCH Softkey. This
feature is only available in the Horizontal Scan Mode.
44
Garmin G1000 Cockpit Reference Guide for the Cessna Citation Mustang
BLACK
LIGHT BLUE
YELLOW
MAGENTA
BLUE
Intensity
0 dB
> 0 dB to < 9 dB
9 dB to < 18 dB
18 dB to < 27 dB
27 dB and greater
190-00600-01 Rev. C