Printing Problems - Epson Stylus NX510 Series Network Installation Manual

Software installation failed
Make sure that the printer is connected to your network (see page 4 for wireless or
page 22 for Ethernet). Then remove and reinsert the CD to reinstall the printer
software.
Cannot communicate on a wired LAN
If you're switching from a wireless to a wired network connection, you need to
disable the wireless adapter using the printer's control panel. Press the
button on the printer's control panel, select
>
Setup Advanced Setup
, then press
Yes OK
The printer does not appear in the Add Printer window (Mac OS X)
Make sure the printer driver was installed correctly and that your computer's
TCP/IP settings are configured correctly.

Printing Problems

Cannot print over the network
■
For wireless connections, print a Network Status Sheet (see page 34). If the
Link Status is Disconnected, make sure the wireless router or access point is
turned on and the settings are correct for your wireless network.
■
For wired connections, print a Network Status Sheet (see page 34) and make
sure the settings are correct for your network.
If the Network Status is Disconnected, try the following:
■
Make sure the Ethernet cable is securely connected to both the printer
and your router, access point, switch, or hub.
■
Try connecting to another port on your router, access point, switch, or
hub.
■
Try connecting the printer to another router, access point, switch or hub.
■
Try connecting the printer to your router, access point, switch, or hub
with another Ethernet cable.
■
When using TCP/IP, make sure the printer's IP address is set correctly for your
network. If your network does not assign IP addresses using DHCP, you need
to set the IP address manually.
>
Manual Setup
.
Network Settings
>
Disable Wireless LAN
Setup
F
>
Wireless LAN
. Select
Troubleshooting
33