Craftsman 320.23465 Operator's Manual page 24

4. Fig. 30
5.
Align the grooves on the
carbide triangular rasp with
the four raised ribs on the
drive shaft; put the disc
onto the drive shaft.
(Fig. 30)
With your gloved hand
holding the carbide
triangular rasp put on and
tighten the flange bolt using
the hex key.
NOTE: The ribs on the
shaft and the grooves in the
accessory tools permit a firm
connection of the accessory
tools in increments of 30 °
around the shaft (Fig. 31).
Apply the accessory tool in the
orientation appropriate to the
task at hand.
USING THE CARBIDE
TRIANGLUAR RASP (Fig. 32)
1.
2.
3.
Connect the Multi-Tool to a
power source.
Put the rasp flat against
the workpiece and apply
appropriate pressure.
Switch on the tool, remove
any hardened adhesive or
grout on the surface of the
wall tiles.
Fig. 31
Fig. 32
23465 ManuaLRevised_lO 0705 Page 24