Craftsman 320.23465 Operator's Manual page 22

_, WARNING: Check that
the accessory tool is correctly
attached. Incorrect or
insecurely fastened accessory
tool can come loose during
operation and cause a hazard.
1.
2.
3.
Disconnect the Multi-Tool
from the power source.
Loosen the flange bolt with
the hex key provided.
(Fig. 24)
Ensure that the inner
threads and the drive shaft
are clean.
4.
5.
Align the grooves on the
scraper blade with the four
raised ribs on the drive
shaft; put the blade onto the
drive shaft. (Fig. 25)
With your gloved hand
holding the blade, put on
and tighten the flange bolt
using the hex key.
NOTE: The ribs on the
shaft and the grooves in the
accessory tools permit a firm
connection of the accessory
tools in increments of 30 °
around the shaft (Fig. 26).
Apply the accessory tool in the
orientation appropriate to the
task at hand.
Fig. 24
Fig. 25
Fig. 26
23465 ManuaLRevised_10 0705 Page 22